Overview of the vacuum enlarger for penis enlargement

vacuum extender for penis enlargement

The aim of the extender is the most comfortable stretch of the penis. This mechanism works only if the head is securely attached. The duration of use of the device depends on how safe and comfortable its installation is, and, accordingly, the speed of progress. The vacuum extender is considered the best option, as well as an improved version - vacuum adhesive. These devices appeared on the market about 10 years ago and since then have significantly replaced mechanical ones.

Design features and principle of operation

In vacuum extenders, the head of the penis is not tied with a loop or string, but is sucked by vacuum into a special bowl (chamber, vacuum nozzle). This device works on the principle of a vacuum pump, but in this case, the effect is only on the head and the area adjacent to it. Air from the chamber, as in a pump, is pumped out by a pump or pear.

The main advantages of models with vacuum fixation:

  • Don't slip;
  • Effectively correct the curvature of the male organ;
  • Do not pinch the head and foreskin;
  • Suitable for micropenis;
  • Comfortable to wear.

The main disadvantage of the vacuum-mounted extender is the appearance of bubbles on the head. This does not happen when mechanical. Damage is caused by tissue delamination under the influence of vacuum. It is impossible to continue classes until the blisters heal, and because they appear regularly, the effectiveness of wearing the device drops significantly.

Many manufacturers equip their products with protective caps to protect the head. Some models are equipped with a filling roller that is supposed to be sealed before placing in the lid. The subsequent gluing and removal procedure causes discomfort and pain.

Some men complain about the inconvenience of wearing such an extension: protection is not glued to a relaxed head, it is necessary to bring the penis to a state of at least partial erection. When wearing the extender, the head shrinks, as a result, a gap is formed between it and the wall of the cap - the skin is again exposed to the traumatic effects of the vacuum.

Schematic of installing a vacuum extender:

  1. Seal the head, put a protective cap on it.
  2. Roll some of the silicone sleeve attached to the top of the camera onto its body.
  3. Place the penis in the chamber, roll the silicone sleeve to the end along the shaft.
  4. Suck up excess air with a blower or pump.
  5. Fix the penis on the elongating rod, adjust the length.

Part of the penis is compressed with silicone, which causes discomfort and impairs blood flow. The covered luggage area is barely extended. If the penis is about 12 cm long, then most of it will be under the silicone crimp.

In advanced models with a vacuum adhesive type of attachment, only the head is sucked into the chamber, and the sleeve is replaced with a soft membrane. The penis and its membranes are pre-lubricated with a special lubricant, then the head is brought into the chamber opening and sucked into it with several movements of a rubber ball. Then disconnected, the device is securely attached to the head. To remove it, simply turn the valve at the top of the chamber. The lubricant attaches the head to the membrane, preventing gaps from forming, which eliminates the appearance of bubbles.

How to use

Before the first insertion of the vacuum extender, the initial length is set - the size of the erect penis. In the future, the compression force is regulated by a spring on the rod (on spring models): if the scale is fully visible (the notch is not closed), then there is no tension. If there is no visible tension with the rod fully opened, then the additional length is increased using the rod included in the kit. The traction strength of the stretcher (belt system) can be determined using a household spring scale.

It is impossible to immediately regulate a large degree of tension: it is possible to compact the albuginea covering the cavernous body, worsening of the erection, edema of the head, lack of growth and even a decrease in the length of the penis. Within a month, a light adaptive load is given. The extender is worn no more than 1-2 hours with a tension strength of 200-400 g, maximum 500 g. When the penile tissue gets used to stretching, you should switch to a more serious mode: 6-8 hours a day (not necessarily continuously) with a load of 1. 1 kg. It is possible to wear the extender with a maximum length (traction power) of only 4 weeks.

Power Growth Program:

  • Remove the extender to the length of the erect penis, stretch it 300-600 g;
  • When used, the load can increase up to 1kg;
  • Wear for 2 hours a day without a break or spend 2 sessions of 1. 5 hours. One day off per week is required.

It is important to measure the length of the penis (stretched, not erect) after each exercise. The increase shows the effectiveness of the selected program. If the penis is reduced, then rest for 2-3 days is necessary.

For a year, with the help of a vacuum extender, it is possible to increase the length of the penis by 3-4 cm, and its thickness by 1 cm. In young people, growth occurs faster than in adult men, due to the high elasticity of the tissues. The result is also highly dependent on the density of the protein layer.

Contraindications

Before buying a vacuum extender, you should consult a doctor - he will help identify any contraindications to its use. The main ones include the following:

  1. Violation of blood coagulation, fragile vessels. The vacuum will trigger the appearance of a hematoma.
  2. Prostate adenoma, prostatitis.
  3. Scrotal hernia.
  4. Sexual infections.

It is dangerous to use a vacuum extender while under the influence of painkillers, drugs or alcohol. It is undesirable to wear the device at night - in a dream it is easy to miss the initial moment of tissue oxygen starvation due to excessive squeezing, and spontaneous nocturnal erections are also dangerous.

Overview of popular models

Most urologists-andrologists recommend a vacuum system with vacuum adhesive fixation to their patients for penis enlargement. The soft membrane protects the head from damage by preventing direct exposure to the vacuum. The vacuum adhesive model is also considered convenient and efficient. This kit includes camera, pear, rod, a set of membranes of various sizes, extension rod, gel. There are detailed instructions on how to properly wear and wear the device. The maximum extender length is 32 cm.

There are kits for upgrading the strap and loop extender. However, the cost is so high that it is easier to buy a vacuum cleaner.

complete set of vacuum extender for penis enlargement

The Korean extender is positioned by the manufacturer as the most comfortable to wear with an additional head enlarger function. Bonded by vacuum adhesive method. This kit includes 3 membranes, 8 screw extension pins.

Method of use:

  1. A membrane of a suitable diameter is stretched on the edge of the chamber, lubricated with lubricant (together with the head of the penis);
  2. The camera is placed on the rod;
  3. The shaft of the penis is placed in the extender, the head is inserted into the chamber;
  4. Pears pump out air.

The device from the Swiss company is a vacuum extender designed for long-term use. According to men, it is recognized as the most comfortable. This kit includes 3 vacuum chambers with condom attached, 4 cuffs, 2 protective caps, pump. This model includes a belt fixation system (stretcher), which allows the use of the extender in public places.

Instructions for use:

  • A protective cap is placed on the head.
  • The penis is threaded between the lengthening rods, the rods are wound until the optimal level of tension is achieved.
  • The head is placed in the space of the appropriate size (a template for determining the size is attached), the condom is rolled into the trunk.
  • A pump in the form of an accordion is attached to the chamber, with its help air is pumped out.

If necessary, the rod is removed, the member with the camera on the head is pulled to the belt with a belt.

Some make their own extenders using bicycle pump cases, plastic, silicone, and plumbing fixtures. It is very difficult to make a truly functional and safe device with your own hands. In terms of quality, such crafts are usually inferior to cheap Chinese extenders.

Review

Male, 44 years old: "I've been wearing the device with a belt stretcher for half a year now. The increase in length is 2cm - a significant result. I supplement traction with a jelq and hanging weights, but rarely.

Man, 25: "I ordered a Chinese kit and I'm thinking of returning it or swapping it for a Korean device before it's too late. Uncomfortable to wear, pinched penis to colic, no question of effectiveness in such conditions.

Conclusion

Swiss, Korean and German vacuum extenders are officially recognized as an effective way of penis enlargement. Comes with detailed video instructions, which eliminates abuse. It is important to consider that regular use of the extender is as important a prerequisite for success as its quality.